These are not my design I'm not taking any credits from the guy who came up with it. I'm just making all the parts and spreading the 2A awareness.
This is a Glock forced reset trigger, similar to a ar15 super safety.
This is a SEMI-drop in glock frt with a printed trigger shoe and metal reset surface. its semi drop in because you have to buy a guide rod and take your stock trigger shoe off your trigger bar. And also file your trigger reset until it fits your setup. you will need to remove the slide release to install the trip surface as it uses the barrel tilt for reset, only for the v1. You will need a stronger recoil spring to counter the forces applied; a 22-pound guide rod is recommended. you may also need to sand the reset surface slightly AT THE TIP! Round off the tip slowly and keep putting it in your setup until you can pass the dry fire function test. Thats if the slide locks back when you pull the trigger with moderate force. Also, you can file and polish the bottom of your barrel, the tip of the trip rubs against the bottom of the barrel in order to reset the trigger. So, it's good to polish, sand, and oil everything, lots of oil especially on the frt metal trigger reset tip and inner curve
you can also get a 3.0 - 3.5 trigger connector for a lighter shorter trigger pull
Also, you can get a lighter plunger spring to help
ar15 bolt catch spring not included with the v2 trigger, you can also use a pilot pen spring.
